
The following is a list of all 30 FAQs in the Controllers category.
- Can I continue to use my kiln-sitter with the controller?
- Can the controller LED displays be repaired if they no longer light up?
- My controller display shows dashes and IdLE and will not start a firing. What does this mean?
- My controller display shows FtL. What does this mean?
- My controller display shows PF. what does this mean?
- My controller display shows PLoG. What does this mean?
- My controller display shows FtC. What does this mean?
- Where can I download a USER MANUAL for the Orton controller?
- How do you clear a PLoG alarm for Autofire2000?
- Why does the controller display show IdLe before I am finished programming it?
- How do I erase an entire USER PROGRAM in the controller.
- Are upgrades available for Orton controllers?
- How do you program the Orton controller for a cooling step?
- My controller display shows a rapid flashing light. What does this mean?
- What is the difference between the Orton Autofire controllers and the Paragon Sentry controllers.
- How do you clear a PLoG alarm for Autofire Plus?
- Why does the kiln make loud clicking noises?
- My controller display shows tC. What does this mean?
- How do I change the AF Express program settings while the kiln is firing?
- My controller display shows tCdE. What does this mean?
- After resetting the controller memory as instructed the temperature on the display is no longer accurate. What happened?
- My Autofire controller completed a firing cycle but the kiln appears to have not heated at all. What could cause this?
- My controller display shows FtH. What does this mean?
- My controller display shows tCL. What does this mean?
- Why does the kiln firing complete at a lower temperature than expected when using Conefire?
- My controller display shows tCr. What does this mean?
- My controller display wont turn on. What could be the cause?
- My controller display shows CPLt at the end of a firing. How do I clear this message?
- How do I restart a 3Button controller program without having to go through all the program steps every time.
- My controller display shows FAIL. What does this mean?
