In 1989, Orton received a patent for inventing downdraft venting of electric kilns. Since that time, Downdraft venting has become the standard method used to vent fumes from electric kilns. With downdraft venting, gases are pulled out of the kiln near the bottom of the kiln and then mixed with room air and exhausted to the outside through a duct.
Downdraft venting systems are considered better than hoods because they improve firing conditions in the kiln while removing essentially all fumes from the kiln room. VentMaster is capable of venting two kilns at once and is easy to install! The motor / blower is built from a non-corrosive, lightweight plastic that allows you keep it on the floor, or mount VentMaster to the wall!
Why Vent My Kiln?
All products fired in electric kilns contain organic materials that make carbon monoxide and other fumes when they are burned. Fumes released may contain sulfur oxides, hydrogen fluoride and metal vapors, depending on the products fired. Carbon monoxide and other fumes can affect the color and properties of the fired product if they are not removed from the kiln earlier in the firing. Red, green, gold and similar products are particularly affected by carbon monoxide at temperatures where the color develops.
Removing released fumes from your work environment is very important, since these are unhealthy to breathe on a regular basis. Carbon monoxide can cause headaches and nausea and other potentially serious health problems.
During operation, the KilnVent system keeps the kiln under a slight negative pressure. This pulls the fumes out of the kiln and pulls in a small amount of fresh air. Firing times are essentially the same. The fumes are exhausted directly into a duct system and removed from the kiln room. Improved air flow in the kiln results in more uniform temperatures, reducing hot and cold spots.
During several test firings without VentMaster, total temperature variances of 77° were produced due to the lack of air circulation. While firing with VentMaster, the temperature variance is reduced to 30°, over 38% more uniform.
With the use of VentMaster, the hot air typically at the top of the kiln, is pulled to the bottom. The variance can be seen above for both scenarios. The firing cones (circled) can be visually compared to determine the approximate variance from top to bottom.
Health and Safety Issues
OSHA has set standards for carbon monoxide exposure of 35 ppm (parts per million) for long- term exposure and 200 PPM for short-term exposure. Independent testing has shown that fumes near the kiln can exceed 200 PPM near the kiln during the firing of greenware. This can cause headaches, fatigue, sore throats and nausea. When properly installed and operated, a downdraft vent removes ALL harmful fumes and provides a safer working environment.
Most states and localities have set venting requirements for firing kilns in public places. Your local and state health board should have this information. The Uniform Mechanical Code lists accepted venting methods. The downdraft system made by Orton is listed in the 1992 approved Code. Orton downdraft vents have been certified by ETL (Intertek Testing Services NA, Inc.), an Internationally Recognized Testing Laboratory).
VentMaster has earned the right to bear the ETL mark in the US, CETL in Canada and CE in European Markets.
| ||VentMaster (110 Volt) ||VentMaster (220 Volt)
||M9 VENTMASTER 220
||115V, 60 Hz., 1.1 amp
||208-240 Volt, 50/60 Hz., .5 amp
||10 lbs. (4.5 kgs)
||4-foot High Temperature Hose2
|Warranty and Service
||Your VentMaster comes with 90 days of telephone support and a one-year limited warranty. "Firing Tips" and other VentMaster information is available 24/7 online in the Resource section. For more information contact Orton directly.
1 “Cubic Feet per Minute”. Normal room conditions will replenish air, no need for makeup air system.
2 Available VentMaster Hose Kit extends length an additional four feet.