The following is a list of all 1 FAQs in the Firing Tips category.

• The tip of the cone is curled up after firing.

Q.  The tip of the cone is curled up after firing.

A.  Potential Cause: If the cone did not fall against something in the kiln causing the tip to bend, then the tip may have been too close to the heat source.

Possible Solution: If you have a gas kiln, move the cone away from the flame. If you have an electric kiln, move the cone further from the heating element.

View all questions in the Firing Tips category of this FAQ? Take me there.

Have a question not listed here? Ask Us!