ASTM C288

Standard Test Method for Disintegration of Refractories in an Atmosphere of Carbon Monoxide

Shows the comparative behavior of refractory products with accelerated exposure to nearly pure CO at 940°F. The sample performance is rated based on the ASTM visual criteria. Specimens shall be 9" x 2 1/2" or 3" square in cross section. Maximum capacity of the test furnace is 50 specimens.

Basic Test Cost: $1030
Hourly Charge for Test Duration: $4 per hour
Sample Inspection During Test: $270

DOWNLOAD REQUEST FORM »

SIGNIFICANCE AND USE

This test method is used to determine the relative resistance of various refractories to disintegration caused by exposure to a CO atmosphere. The results obtained by this method can be used to select refractories that are resistant to CO disintegration.

This test method is suitable for research and development and for establishing CO disintegration criteria for specification acceptance.

The disintegration of test specimens is accelerated by providing a higher concentration of CO than anticipated in most service environments. The effects on the test specimens may be different than those found for refractories in actual service conditions.

1. SCOPE

1.1 This test method covers the comparative behavior of refractories under the disintegrating action of carbon monoxide (CO). The test method is an accelerated exposure to CO to determine potential material behavior in a relatively short time.

COPYRIGHT NOTICE

Extracted, with permission, from ASTM C288 Standard Test Method for Disintegration of Refractories in an Atmosphere of Carbon Monoxide, copyright ASTM International, 100 Barr Harbor Drive, West Conshohocken, PA 19428. A copy of the standard may be purchased from ASTM International, phone 610-832-9555, e-mail: service@astm.org, website: www.astm.org.

PURCHASE FULL STANDARD »

View Products by Category:

 

Search
clear

FROM THE BLOG...

Introducing a new two day course: Advanced Thermal Properties of Refractories

ADVANCED THERMAL PROPERTIES OF REFRACTORIES - October 29 & 30, 2018 A Two Day Course Sponsored by...

Orton Ceramic Announces 7 New Course Offerings

In response to industry demand, Orton is offering a series of new short courses dealing with refractories...

Measuring Flexural Creep of Ceramic Investment Casting Shells

Measuring Flexural Creep of Ceramic Investment Casting Shells Understanding the creep behavior...