ASTM C862

Standard Practice for Preparing Refractory Concrete Specimens by Casting

Five brick specimens are prepared using the water content determined in ASTM C-860. This procedure assures the preparation of uniform samples for testing purposes. At least 50 lbs. of each material for testing should be submitted. Mixing is performed in a Hobart mixer and casting is performed either by spading or by vibration.

$270 per test of 5 specimens

DOWNLOAD REQUEST FORM »

SIGNIFICANCE AND USE

This practice is used to standardize mixing, mold conditions, placement and curing of refractory concrete specimens to be used for testing and evaluation under other test methods.

This practice standardizes laboratory conditions for producing refractory concrete specimens to minimize laboratory-to-laboratory variation and does not attempt to duplicate the conditions of field installations.

This practice can be used for the preparation of specimens used in referee testing.

1. SCOPE

1.1 This practice covers the mixing, casting and curing of monolithic refractory concrete specimens for use in further testing. It does not apply to monolithic castable refractories intended primarily for gunning applications.

1.2 The values given in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 Various specimen sizes are required for specific test methods. Refer to these test methods to determine the size and number of specimens, which will be required from the sample.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

COPYRIGHT NOTICE

Extracted, with permission, from ASTM C862 Standard Practice for Preparing Refractory Concrete Specimens by Casting, copyright ASTM International, 100 Barr Harbor Drive, West Conshohocken, PA 19428. A copy of the standard may be purchased from ASTM International, phone 610-832-9555, e-mail: service@astm.org, website: www.astm.org.

PURCHASE FULL STANDARD »

View Products by Category:

 

Search
clear

FROM THE BLOG...

Introducing a new two day course: Advanced Thermal Properties of Refractories

ADVANCED THERMAL PROPERTIES OF REFRACTORIES - October 29 & 30, 2018 A Two Day Course Sponsored by...

Orton Ceramic Announces 7 New Course Offerings

In response to industry demand, Orton is offering a series of new short courses dealing with refractories...

Measuring Flexural Creep of Ceramic Investment Casting Shells

Measuring Flexural Creep of Ceramic Investment Casting Shells Understanding the creep behavior...