ASTM C199

Standard Test Method for Pier Test for Refractory Mortars

A multiple brick pier is made with 1/8" thick vertical and horizontal joints. The assembly is air and oven dried, and then fired for 5 hours at the specified temperature. If the mortar flows from the joints during firing, it fails the test. At least 10 lbs. of mortar should be submitted of analysis.

  FIRING TEMPERATURE PER TEST
Medium Duty 2550°F $780
High Duty 2730°F $860
Super Duty 2910°F $1050
High Alumina 3100°F $1140

DOWNLOAD REQUEST FORM »

SIGNIFICANCE AND USE

This test method is used to estimate the application temperature limits of a refractory mortar and will establish its classification.

This test method will be regarded as a pass or fail test because the results are based on observations of whether the mortar flowed from the joints as a result of the heat treatment used.

Results obtained by this test method will not agree with those obtained in service when heating is done from only one side.

This test method is not applicable for testing nonaqueous mortars.

1. SCOPE

1.1 This test method covers the determination of refractoriness of all types of refractory mortar by heating a pier of brick laid up with the test mortar to learn whether the prescribed heat treatment causes the mortar to flow out of the joints.

COPYRIGHT NOTICE

Extracted, with permission, from ASTM C199 Standard Test Method for Pier Test for Refractory Mortars, copyright ASTM International, 100 Barr Harbor Drive, West Conshohocken, PA 19428. A copy of the standard may be purchased from ASTM International, phone 610-832-9555, e-mail: service@astm.org, website:www.astm.org.

PURCHASE FULL STANDARD »

View Products by Category:

 

Search
clear

FROM THE BLOG...

New International Ordering Options Available

Orton has partnered with Zonos and United Parcel Service so Customers around the world can order small...

Shelf Life of Cones

Do cones have a shelf life? At the Edward Orton Jr. Ceramic Foundation, a common question asked to...

New Test Equipment Installed

Orton's Materials Testing Service Department recently added a new laser flash machine to measure thermal...