ASTM C1025

Standard Test Method for Modulus of Rupture in Bending of Electrode Graphite

Flexural strength is determined in four-point bending on 6" x 1 1/2" x 1 1/2" specimens.

$50 per specimen

DOWNLOAD REQUEST FORM »

Significance and Use

This test method provides a means for determining the modulus of rupture of a square cross section graphite specimen machined from the electrode core sample obtained according to Practice C783, with a minimum core diameter of 57 mm. This test method is recommended for quality control or quality assurance purposes, but should not be relied upon to compare materials of radically different particle sizes or orientational characteristics. For these reasons as well as those discussed in 4.2 an absolute value of flexural strength may not be obtained.

Specimen Size-The maximum particle size and maximum pore size vary greatly for manufactured graphite electrodes, generally increasing with electrode diameter. The test is on a rather short stubby beam, therefore the shear stress is not insignificant compared to the flexural stress, and the test results may not agree when a different ratio or specimen size is used.

 

1. Scope

1.1 This test method covers determination of the modulus of rupture in bending of specimens cut from graphite electrodes using a simple square cross section beam in four-point loading at room temperature.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use

 

Copyright Notice

Extracted, with permission, from ASTM C1025 Standard Test Method for Modulus of Rupture in Bending of Electrode Graphite, copyright ASTM International, 100 Barr Harbor Drive, West Conshohocken, PA 19428. A copy of the standard may be purchased from ASTM International, phone 610-832-9555, e-mail: service@astm.org, website: www.astm.org.

 

Purchase Full Standard »

View Products by Category:

 

Search
clear

FROM THE BLOG...

TempTab Brochure for the Dental Industry Announced

Verifying temperatures in your Sintering Furnace?  The August Buyers Guide of LMT magazine offers TempTab...

High Temperature Ceramics for Extreme Environments Workshop - June 18 & 19, 2019

The Ohio State University College of Engineering Department of Materials Science and Engineering...

2019 Introduction to Refractories Short Course

Orton's 2019 "Introduction to Refractories" short course is coming up in August. This course is an intensive...